Home / Resources / Hardware & PCB
HARDWARE & PCB

HDI PCB design for compact connected controllers

An engineering guide to defining constraints, BGA escape routing, microvias, high-speed layout and manufacturing release.

Published 15 November 2026 · 7 min read · Engineering guide

Start with constraints, not traces

Compact controllers bring together processors, memory, RF, interfaces and power in a constrained enclosure. Capture the electrical, mechanical, thermal and manufacturing limits before placement: available board outline, BGA pitch, connector geometry, stackup options, antenna clearance, peak power and test accessibility. A smaller board is not automatically the least expensive board.

Choose the stackup for signal paths and manufacturability

HDI offers blind microvias and fine interconnect features to escape dense packages. Choose via structures and layer count with a fabrication partner; stacked microvias can increase process complexity and cost. Define reference planes before routing so high-speed return paths stay continuous. Use controlled-impedance calculations and fabrication tolerances rather than assuming a single trace width works for every layer.

Partition placement around systems

Place processors and DDR close enough to meet timing and topology limits; keep clock trees and sensitive analog circuits away from noisy switching nodes. RF paths need deliberate shielding, matching access and antenna keep-outs. Position converters to minimize high di/dt current loops. Reserve mechanical clearance for connectors and service access.

BGA fanout & differential channels

Decide which balls require short escape vias, which can leave on outer layers and where via-in-pad is justified. Differential pairs should be routed with consistent geometry and a solid return path. Pair length matching is a secondary constraint after the correct topology, impedance and return-current control. Excess tuning serpentines can create their own discontinuities.

SI, PI and EMC are one physical design problem

Check eye margins and reflection risk on high-speed links. Verify the power-distribution network across the operating frequency range, not just at DC. Decoupling placement, layer transitions and ground-current paths influence both power noise and radiated emissions. For RF, validate matching and isolation using measurements appropriate to the device and frequency band.

Design for fabrication, assembly and test

Run DRC/DFM and DFA reviews with the intended supplier. Examine solder mask clearances, stencil apertures, copper balance, drill/annular-ring rules, via fill, board panelization and assembly access. Provide fabrication drawings, stackup and impedance requirements, BOM with alternates, assembly notes, pick-and-place files and test criteria.

Engineering takeaway

HDI should be justified by density, reliability and electrical performance. A clear stackup, intentional placement and early manufacturing review usually save more time than an aggressive routing-only approach.

Practical release checklist

  • Requirements and interfaces reviewed with owners
  • Stackup, impedance and fabrication limits approved
  • BGA, DDR, RF and power critical constraints verified
  • SI/PI/EMC review completed to the required product risk level
  • DFM, DFA, test plan and release package baselined