Home / Resources / Signal & Power Integrity
SIGNAL & POWER INTEGRITY

Signal integrity and power integrity essentials

Eye diagrams, sample timing, controlled impedance, return-current paths and PDN design for reliable high-speed boards.

Published 15 November 2026 · 8 min read · Engineering guide

Understand the channel, not just the waveform

Signal integrity (SI) is about delivering a recognizable symbol to its receiver under real interconnect, noise and timing conditions. The channel includes driver, vias, traces, connectors, packages, termination and receiver. Power integrity (PI) provides stable supply voltage over DC and the relevant transient frequency range. The two are related but should be analyzed separately and jointly.

What the eye diagram actually shows

An eye diagram overlays many unit intervals (UIs). For a conventional NRZ display centered on the symbol, sample near the middle of the symbol interval, UI/2 after the nominal transition boundary, where the vertical opening is often largest. The optimum decision instant depends on jitter, equalization, receiver timing recovery and the actual channel. Horizontal eye opening indicates timing margin; vertical opening indicates noise margin.

Conceptual eye diagram displaying a center sampling line
Illustrative eye opening, not a measured compliance mask. Center line indicates the nominal decision instant.

Impedance and the return path

A discontinuity in characteristic impedance produces reflections. Maintain consistent trace geometry and reference planes, account for package and connector parasitics, and avoid unnecessary stubs. A differential pair still needs an electromagnetic return path; split planes, poor via transitions and discontinuous references can increase radiation and mode conversion.

PDN impedance versus transient current

The PDN is not described adequately by a nominal voltage or capacitor count. Use target impedance as a starting point: Ztarget ≈ ΔVallowed / ΔItransient. Then consider regulator response, bulk/ceramic capacitors, mounting inductance, plane behavior and package impedance. A frequency-dependent impedance profile helps identify resonances; time-domain transients reveal whether the rails remain in tolerance during actual load events.

Measure and correlate

Simulations should use realistic IBIS/SPICE/S-parameter models when available. Instrument selection matters: sufficient bandwidth, differential probing, fixture de-embedding and disciplined grounding are essential to avoid measuring the fixture rather than the product. Correlate pre-layout, post-layout and lab data before declaring the interface stable.

Design review checklist

  • Correct receiver threshold and sampling assumptions
  • Specified impedance, topology and termination
  • Continuous return current across crossings and vias
  • Acceptable eye margin for the target BER/protocol
  • PDN target, resonance and transient-load evidence
  • EMI/EMC risk and measurement plan documented
Engineering takeaway

A visually open eye and a low-noise supply are evidence only when the test setup, margins, operating corners and acceptance criteria are defined.